Resonant Cavity

N) Resonant Cavity:

PURPOSE: To enhance hydrogen gas production beyond voltage attenuation by way of compounding-action (particle impact)

Circuit Stage:

Integrating dual-pulsing circuit (33) (34) (38) (39) (40) to voltage intensifier circuit (Figure 9) previously described), as shown in Figure 20C.

As shown in Figure 20C. variable gate circuit (32) is a two-state switch device which is directly Tinkedlinked to both optocoupleropto-coupler (36) and optocoupleropto-coupler (39). As (H) near ground or low state (0 volts), optocoupleropto-coupler (36) is triggered on. allowing pulse voltage frequency (d) as to (e) to form.

Once said gate circuit (32) changes state (low to high voltage or versa), trigger pulse (J) turns on optocoupleropto-coupler (39) to form voltage wave form (f) as to (g).

Triggered pulse (H) is now terminated, switching off said wave form (d) (e).

Repeating said alternate gate switching produces dual-voltage pulse-train (51) of Figure (16).

Wave form (d) (e) and wave form (f) (g) now pulse-duty (52) which is varied from one duty-pulse one hundred duty-pulses (establishing pulse-train 51) via gate circuit (32) (tenth and eleventh steps to voltage attenuation).

The reoccurring duty-pulse (52) is now attenuated to provide maximum gas-yield while minimizing amp flow.

This is accomplished in several ways:

1. Gated Pulse (H) as to gated pulse (J) applied voltages ta sa changed
 said applied voltages resonant Said gated pulse train (53, on time) as to (54, off time) is adjustable from 1% to 100% duty time.

As on-time (53)
 increases, off-
time (54) proportionally decreases,
 allowing more voltage pulses (53)
 to be applied to said resonant cavity (44).

To reduce the number
voltae voltage pulses (53),
 simply reverse the pulse-train adjustment of said
 gate control circuit (32).
 gated pulse-train
 (51) is
 maximizing
 production,
 duty-cycle pulse (52) is now varied from
 duty-pulse
 per second duration (52a) to one hundred
 gas one per
 second duration (52n) to help restrict amp flow.

2. Said said
 voltage amplitude (d) is varied to increase voltage
 amplitude (d) is stepped up,
 gas-yield.
yield, applied voltage range
After after to
 said cavity (44) is from less than one volt to 5,000 volts or more.

3. Said voltage
 pulse frequency (e) is now varied from 1Hz1 Hz to IMHz1 MHz and
 more, increasing gas-yield still further.

Said voltage amplitude (f) is varied to sustain and compounding-action
 within said resonant cavity
 (44). Said voltage amplitude
 (f) is adjusted
 as to cavity-size.
maintain
said
(44).
Said
voltage
 An increase in voltage
 amplitude (f) is required as cavity-size increases.

Once compounding-action is properly maintained,
 voltage amplitude (f)
 is
 adjusted "no" further to keep amp
 flow to a minimum (twelfth
 step