The archive
Everything the archive has gained lately, newest first. Also as a feed for whatever you read feeds with.
13,572 items
calculation · WFC · · added 1 month ago
**Sweep** — Fine ppm grid 0.1-0.5 at low temp to locate ionic-branch knee, jointly with reduced surface_factor to test double-layer area reduction for current margin recovery - **C...
design note · WFC · · added 1 month ago
Lab note, 3 July — ppm/surface sweep at low temp. Findings confirm the ionic-branch knee sits right at 0.1ppm Na+ near 3°C: bulk water R climbs to ~128kΩ and the Randles series res...
design note · WFC · · added 1 month ago
Design Note — 2026-07-03 Pushed ppm below the 0.1 knee and temp toward 0°C (all top candidates landed at 0.1ppm, 3°C — the sweep floor, not quite 0°C) to see if series current woul...
design note · WFC · · added 1 month ago
Ran the geometry-#1 cell down to the 0-1°C floor while cutting surface_factor to 0.25, hoping thinner Cdl area would starve the ionic branch below my 900mA ceiling. It didn't break...
design note · VIC · · added 1 month ago
Ran the wide choke sweep to see if pulling away from the 130t/1mH anchor would find a higher-Q regime, and it did answer the question — just not usefully. Dropping to 0.1mH (40-70...
design note · VIC · · added 1 month ago
Lab note — mapping the 1mH-to-0.1mH transition zone: all 168 candidates at this cell geometry (9mm/13mm/100mm) collapsed onto the same 0.1mH choke value with f_r pinned at 326.82kH...
design note · VIC · · added 1 month ago
Ran the tube/gap sweep to push C_eff up an order of magnitude — got there: 1.19nF vs the ~0.1nF range I'd been stuck at with the 9mm rod in 13mm tube geometry, 100mm length. But ra...
calculation · VIC · · added 1 month ago
**Sweep** — Prior L sweeps (0.15-2.5mH) with 3-4 parallel cells never landed f_r in-band; test unexplored 0.02-0.15mH low-L region plus 2.5-5mH high-L region, both at Q-preserving...
design note · VIC · · added 1 month ago
Ran the low-L bracket (0.02-0.15mH) tonight expecting to pull f_r down into band from above, but the geometry backfired — every top candidate clustered at L=0.1mH and landed at 326...
calculation · VIC · · added 1 month ago
**Sweep** — Fine-grid mid-L structural band (0.3-0.8mH) with untested 0.2-0.3mH edge, crossed with wider AWG/turns combos to find higher-Q in-band f_r solutions beating 0.73 withou...
design note · VIC · · added 1 month ago
Lab note, 2026-07-10 — mid-L sweep (0.3-0.8mH band + 0.2-0.3mH edge) All five top candidates converge on the same 0.0002H choke value regardless of AWG/turns fill — the geometric C...
calculation · WFC · · added 1 month ago
**Sweep** — Hold ppm/temp at #1-4's avalanche-crossing values (0.1ppm, 60C) and sweep geometry — larger rod OD, wider gap, longer electrodes — to pull f_r below 100kHz without drop...
breakthrough · WFC · · added 1 month ago
- **Cell** — 18mm rod in 24.0mm tube × 50mm, 1 cell(s) parallel → C_eff = 0.65nF, bulk water R = 70315Ω. - **Water/electrodes (Randles)** — 0.1ppm Na+ @ 60°C, surface ×1 → λ_D 250n...
design note · WFC · · added 1 month ago
Lab note — vapor-film sweep around the #4 cell. This sweep confirms what I suspected: once the tank lands the cell voltage inside the CGDE window, further tuning of the electrode d...
established · · added 1 month ago
The measurement setup relies on a light-detector positioned along the tube to detect the flame front, with the burn-rate calculated from the linear distance traveled between the sp...
calculation · WFC · · added 1 month ago
**Sweep** — Walk f_r down from ~98kHz toward 60kHz around adopted #1 cell by raising C_eff via colder water (higher εr) and longer/multi-cell electrodes, while testing whether the...
design note · VIC · · added 1 month ago
Tried "larger L" literally and it broke: sweep spec asked for 10-40H per choke (clamp ceiling 10H), giving L_total up to 20H against the current ref cell (WFC v25 geometry, ~1.4nF)...
design note · WFC · · added 1 month ago
Design note, 2026-07-18 All five candidates land in the same regime — ultra-pure water (0.1–0.15ppm), near-freezing, ×0.25 surface treatment, same 8-cell/2-choke geometry — and eve...
design note · VIC · · added 1 month ago
Design note, 18 July 2026 This sweep locked the cell geometry (18mm rod/34mm tube, 8-cell parallel, C_eff 1.37nF) and let the choke live-vary in turns/gauge while everything else h...
established · VIC · · added 1 month ago
The resonant frequency (F) of a series LC circuit is given by Eq 4, and Ohm's Law for the series LC circuit is also provided in the text (exact equation not transcribed). Source: T...
established · VIC · · added 1 month ago
The voltage (VL) across the inductor (C) is given by equation (Eq 6), and the voltage (VC) across the capacitor is given by equation (Eq 7), describing the step-up relationship in...
design note · VIC · · added 1 month ago
Lab note — VIC choke sweep (48 candidates, RANDLES + vapor-film CGDE diagnostic) This sweep swept only the choke: L, turns, wire gauge. All 48 collapse onto essentially the same op...
design note · VIC · · added 1 month ago
Lab notebook — VIC resonant sweep, 0.1mH choke gap This session tried to thread the 0.1–0.8mH per-choke gap, co-varying turns and gauge to walk f_r down from 300kHz toward the prac...
established · MISC · · added 1 month ago
Injecting 'Electromagnetically Primed' and 'Electrically Charged' combustible gas ions (produced from water) into other light-activated Resonant Cavities further promotes gas-yield...
design note · VIC · · added 1 month ago
This sweep let me vary only the choke — inductance, turns, wire gauge — and the flat 0.274 plateau across the top four tells the real story: with L pinned at 100µH each side, I've...
design note · VIC · · added 1 month ago
Choke sweep, session note. I pushed L up to drag f_r into the practical 1-100kHz drive band with the AWG18/20-turn winding held fixed. The physics is a clean trade and it's frustra...
calculation · VIC · · added 1 month ago
**Sweep** — screen-guided: live [Choke L (each), Turns, Wire gauge], refined score 0.274 - **Cell** — 18mm rod in 34.0mm tube × 25mm, 8 cell(s) parallel → C_eff = 1.37nF, bulk wate...
design note · VIC · · added 1 month ago
This sweep drove home a hard constraint I keep bumping into: with a 1.37nF cell and a 100µH choke on each side, resonance lands at 303.9kHz — dead outside my practical 1–100kHz ban...
design note · VIC · · added 1 month ago
This session was supposed to walk the sub-0.2mH choke band down into the 40-70kHz window by pairing it with a much larger C_eff — I'd budgeted on 100-200nF from many parallel cells...
calculation · VIC · · added 1 month ago
**Sweep** — Fine-grid the choke around #1's 0.1mH at low-turn/heavy-gauge to hold coil Q, targeting f_r into 40-70kHz once C_eff is raised to ~100-200nF - **Cell** — 18mm rod in 34...
