Skip to content
Stan’s Legacy

(53) · also written as a run, 53a xxx 53n

Electrical Load

Also written Voltage Pulse Train · voltage pulse-train · light bulb

Where it is first named

As unipolar Voltage Pulse Train (53a xxx 53n) of Figure 20FB Section AA is applied to said voltage intensifier assembly 9XA1 as to Figure schematic 9XA, an analog voltage pulse train (55) of Figure 20FB is formed in a linear direction.
Hydrogen Gas Gun Technology

How it is written

  • (53)
  • (53a xxx 53n)

53a xxx 53n is Meyer's shorthand for a run of the same thing: 53a is the first, 53n the last, and the x's stand for however many lie between. Every stage of the run is this one numeral.

Drawings 1

Where it is named · 7

Hydrogen Gas Gun Technology

  1. Voltage Pulse Train (53a xxx 53n)

    As unipolar Voltage Pulse Train (53a xxx 53n) of Figure 20FB Section AA is applied to said voltage intensifier assembly 9XA1 as to Figure schematic 9XA, an analog voltage pulse train (55) of Figure 20FB is formed in a linear direction.

    Read it there →

  2. voltage pulse-train (53a xxx 53n)

    The atomic energy-yield from water is simply controlled by varying the applied voltage pulse-train (53a xxx 53n) since said thermal-lens assembly is self-adjusting to the flow-rate of said ionized and primed gases.

    Read it there →

  3. electrical load (53)

    The Electron Extractor Grid (51) is attached to an electrical circuit (180) that allows electron flow (56) to pass to an electrical load (53) by electrical wire (52) when a positive electrical potential (54) is placed on opposite side of said electrical load (53)

    Read it there →

  4. electrical load (53)

    The Electron Extractor Grid (51) is attached to an electrical circuit (180) that allows electron flow (56) to pass to an electrical load (53) by electrical wire (52) when a positive electrical potential (54) is placed on opposite side of said electrical load (53)

    Read it there →

  5. electrical load (53)

    ...electrical load (53) being a typical light bulb or amp consuming device.

    Read it there →

  6. light bulb (53)

    As the positive electrical potential (54) is switched on or pulse-applied, the negative charged electrons liberated from the Hydrogen Fracturing Process are drawn away from said Gas Resonant Cavity (110 of Figure 20 JX) and enters into said light bulb (53) (by way of opposite polarity attraction) having resistive filament wire (55).

    Read it there → · on Figure (20)

  7. Electrical Load (53)

    Blocking diode (14) directs the electron flow (56) to said Electrical Load (53) while resistive wire (55) prevents voltage leakage during pulse train (61) "ON" time.

    Read it there →