calculation · Voltage Intensifier Circuit · computed
VIC design session v111: best candidate (Q=14.9, 94.8kHz)
Sweep — Hold near the AWG18 1mH/200T champ but exploit coupled-mode L-splitting (fine grid straddling champ) crossed with a mid/low peak_v ladder to slide the 470 Td film down into the 80-250 Td CGDE band without sacrificing loaded Q, scoring the leakage-robust point.
- Cell — 20mm rod in 23.0mm tube × 50mm, 1 cell(s) parallel → C_eff = 1.56nF, bulk water R = 16412Ω.
- Water/electrodes (Randles) — 1ppm Na+ @ 25°C, surface ×0.5 → λ_D 75nm, C_dl 7.8µF, cell series R 70.4Ω, displacement current 93.8%, breakdown margin ×155.
- Fig-8 voltammetry (4,798,661) — τ_EDL 127883.8µs (12127.5 carrier cycles to charge), Faradaic leakage at peak 50.1mA (leak score 0.65 — keep amp leakage inhibited while voltage climbs the ladder).
- Vapor-film discharge (CGDE onset, 596V across 0.1mm film) — regime sub-breakdown, film Paschen 684V, 238 Td — INSIDE the 3-6 eV cold-chemistry window.
- Townsend α/γ — γ = 0.02 (electrode lever), criterion M = γ(e^{αd}−1) = 0.212 → SUB-CRITICAL, the target corner: avalanche multiplying, γ feedback still open, gas stays cold.
- Per-molecule (series micro-capacitor chain) — 5.56M molecules across 1.50mm → 107.34 µV/molecule (polarization (µV band)).
- Chokes — 2 × 0.0009H (180 turns, AWG 18, 21m wire, AC R 0.8Ω each).
- At resonance f_r = 94.83kHz — Xl = 1073Ω, Xc = 1073Ω, tank Q = 14.9, coil Q = 691.4.
- Cell voltage 596V from 40V drive (×14.9). Tank current 0.56A circulating (CW upper bound — rate wire/switch for this); average input 11mA at 2% duty.
- No hard violations (band, wire length, dielectric). Average current is scored, not gated.
- Score 0.638.
Basis
- Confidence
- 0.70
- Method
- townsend-v5
- Recorded
- Published
- 30 Aug 2026
- Device
- Voltage Intensifier Circuit
- Component
- choke
- Source Ref
- design session v111
- Notebook Id
- 1641
design-loop Q resonance