Skip to main content

ESP32 - Complex Waveform Generator V3

Installing and Using the ESP32 Complex Waveform Generator V3 Application

Prerequisites

To use this application, you need to have the Arduino IDE installed on your computer. You can download the Arduino IDE from the official website: https://www.arduino.cc/en/software

Installing required libraries

  1. ArduinoJson: To install the ArduinoJson library, follow these steps: a. Open the Arduino IDE. b. Click on Tools in the menu bar, then Manage Libraries. c. In the Library Manager window, search for "ArduinoJson" in the search bar. d. Find "ArduinoJson by Benoit Blanchon" in the search results and click on the Install button.

  2. ESP32Encoder: To install the ESP32Encoder library, follow these steps: a. Open the Arduino IDE. b. Click on Tools in the menu bar, then Manage Libraries. c. In the Library Manager window, search for "ESP32Encoder" in the search bar. d. Find "ESP32Encoder by Gil Mora" in the search results and click on the Install button.

Uploading the Application

  1. Download the source code for the ESP32 Complex Waveform Generator V3 application or copy it to a new file in the Arduino IDE.
  2. Connect the ESP32 development board to your computer using a USB cable.
  3. In the Arduino IDE, select the appropriate board and port under Tools > Board and Tools > Port.
  4. Click on the Upload button (right-facing arrow icon) in the Arduino IDE to compile and upload the application to the ESP32 development board.

Hardware Setup

  1. Wire the rotary encoders and other components according to the pin assignments defined in the source code.
  2. Make sure the connections are secure and verify the CLK/DT pins for each encoder are wired correctly.

Using the Application

  1. Power on the ESP32 development board.
  2. Use the rotary encoders to adjust the following parameters:
    • Pulse count
    • Pulse width
    • Pulse spacing
    • Off-time
    • Width modifier
    • Spacing modifier
    • Off-time modifier
  3. The application will generate a complex waveform based on the adjusted parameters.
  4. Connect the output pins (channel1OutputPin and channel2OutputPin) to an oscilloscope to visualize the generated waveform.
  5. Fine-tune the parameters using the rotary encoders to achieve the desired waveform shape and characteristics.

Troubleshooting

  1. If the waveform does not match the expected output, verify the wiring connections and ensure the rotary encoders are functioning correctly.
  2. If the application does not upload to the ESP32 development board, double-check the board and port selection in the Arduino IDE.
  3. If the rotary encoders behave unexpectedly (e.g., adjusting one parameter affects another), check the CLK/DT pin assignments and wiring.

For further assistance or to report any issues, contact the application's support team or refer to the community forums.

Back to top