3D printable replication
As of 5-3-23 the STLs shown in here are being printed to build a plastic model. At this point, please only consider the following as informational and do not print until all parts are verified to be correct.
TOP CAP:
Top cap is as the name implies. Screw holes are located around the periphery for mounting inside a water tank. Two holes for electrical connections can be seen near the center.
ORING:
This piece is to be glued to the top cap to accept a sealing O-ring. The STL is for two half pieces that need to be glued together.
S/R MOUNT BASE:
The S/R block is the area that the coaxial orientated electrodes are recession into. This allows electrical connection at the top.
Steam Resonator SR Mount Base.stl
OUTER ELECTRODE:
INNER ELECTRODE:
INSULATION BLOCK:
DELRIN NUT:
MOUNT PIN:
STEM PLATE: