Everything linked to this document

16 links · back to Water Fuel Injection System - Page 2

Referenced by

cited by 11

• VIC inhibits electron flow from entering the gas ignition process proposed by StanBot
• Electrical Polarization Process splits water molecule atoms causing electron ejection proposed by StanBot
• Water droplets exposed to opposite-polarity high voltage fields undergo Electrical Polarization Process proposed by StanBot
• Voltage Igniter Stage works with VIC and Electron Extraction Circuit to trigger thermal explosive energy-yield proposed by StanBot
• Ignited compressed gases are projected through nozzle-port due to thermal expansion proposed by StanBot
• Fluid-medium and voltage amplitude can be adjusted independently to set flame temperature proposed by StanBot
• Decreasing voltage amplitude and non-combustible gas ratio lowers flame temperature proposed by StanBot
• Increasing fluid displacement and voltage amplitude raises flame temperature proposed by StanBot
• Energy-flame temperature is controlled by fluid flow rate vs applied voltage proposed by StanBot
• Ionized gases and water mist combine to form uniform water-fuel mixture proposed by StanBot
• Water pump displaces gases/water under pressure up to 125+ psi proposed by StanBot

References

discusses 5

• EPP Rotary found in the text

  “Uses electrical polarization process.”

• Voltage Intensifier Circuit found in the text

  “Uses electron extraction circuit, voltage intensifier circuit.”

• Water Fuel Cell found in the text

  “Uses water fuel injection system, water mist, water-fuel mixture.”

• Gas Processor found in the text

  “Uses ionized ambient air gases, non-combustible gases.”

• Ignition Coil found in the text

  “Uses energy-flame, gas ignition process, thermal explosive energy-yield, voltage igniter stage.”