3D STL Files

Author does not accept and liabilities/responsibilities for those individuals who chose to build the below cell. This information on this site is for educational purposes only.&nbs...

Plate for mounting 4 rotary switches (3/8" diameter threads), 1 precision 10-turn potentiometer (3/8" diameter threads), and 1 5mm LED.  Variable Pulse Freq Gen Component fron...

  meyer_bobbin_ends.stl

End cap for holding VIC5 bobbin. Bottom has hexagonal recess for 5/16" nylon lock nut. Best method is to lay flat, line up nut flat edges and lightly tap with hammer flush into rec...

As of 5-2-23, the below STLs are currently being printed and tested. It is recommended until verification of the parts is completed, that the content herein should be for informati...

As of 5-18-23, STLs are being printed to test assembly. At this time, until this banner is removed, please do not attempt printing. Verification is needed before others waste time...

Stan had a "triple stack" which was composed of three individual resonant cavities stacked on top one another. These were large and made of machined Delrin. At the top of each was...

As of 5-3-23 the STLs shown in here are being printed to build a plastic model. At this point, please only consider the following as informational and do not print until all parts...

Please be aware that new templates will be added when DIY machining techniques are tested. Check regularly until this banner is removed - indicating the below listed have been fina...