observation · Voltage Intensifier Circuit · computed
Hand-drawn "VIC Coil Pack" wiring sheet: Sec S -> diode -> C1 F, C1 S -> "+"; Sec F -> C2 S, C2 F -> "-"; all coils wound clockwise; 220 ohm across primary
Image shared by Chris Freedom, Discord #neuralstan20-testing 2026-10-30. Pencil sheet titled "VIC Coil Pack" (author not stated on sheet; provenance to confirm, possibly Don Gabel's notes on the estate pack). As read from the drawing: secondary start (S) -> diode (labelled "mur 1550" as written) -> C1 finish (F); C1 start (S) -> "+" output. Secondary finish (F) -> C2 start (S); C2 finish (F) -> "-" output. Note "All coils wrapped in same direction Clockwise". 220 ohm resistor across primary (matches notebook #3442 VIC5 primary shunt). Feedback coil with start/finish and a N/C lead. Driver side: 12 V in, 5 V regulator, two TIP120, one TO-3 marked "2N3005" (probably 2N3055), DB9, terminal strip 1-22 with "1-5 NC" and "13-19 N/C", B+/B-. IMPLICATION: if this is the same pack Don measured, C1 (1218.8 mH on core, 76.7 ohm) is the choke on the diode/positive leg = choke 56 in Fig 3-22, supporting Chris's assumption C1 = positive. Loop current Sec F->S, C1 F->S, C2 F->S: with same winding direction and same bobbin orientation the chokes are series-aiding with the secondary, consistent with "aiding fields" in BoNT Electron Bounce text (bobbin orientation not confirmed).
Basis
- Recorded
- Published
- 30 Oct 2026
- Stanbot
- v3
- Source Ref
- Chris Freedom image, Discord 2026-10-30; Don Gabel VIC coil readings https://stanslegacy.com/documents/vic-coil-readings-don-gabel; notebook #3438, #3442, #3472
- Notebook Id
- 3506
vic5 chokes wiring polarity don-gabel