Skip to content
Stan’s Legacy The Stanley Meyer Archive
Sign in

established · Voltage Intensifier Circuit · computed

Sixth collision: Figure 1-19 is the Gas Resonant Cavity in Memo WFC 420 but is cited as the bifilar VIC core assembly by 423 DA; no Section 3 exists for 423 DA in the available set

  1. FIGURE 1-19 COLLISION (sixth documented mode; see #3366, #3369, #3374, #3378 for the others).
  • Per Scotchn (2026-09-13), Figure 1-19 in MEMO WFC 420 is the GAS RESONANT CAVITY.
  • But Memo WFC 423 DA Series B sheets cite 1-19 for coil construction: Fig 4-2 specifies windings "BIFILAR-WRAPPED AS PER FIGURE 1-19A/B", and Fig 4-13 marks its chokes "RESONATE CHARGING CHOKES [SEE VIC CORE ASS'Y FIGURE (1-19A/B)]". Either two different Figure 1-19s exist in different memos, or 423 DA's Section 1 is not Memo 420's Section 1. OPEN — do not assume either resolution without a headered scan of the 1-19A/B referenced by 423 DA.
  1. THE GAS RESONANT CAVITY CARRIES AT LEAST FOUR DIFFERENT LABELS ACROSS DOCUMENTS — a single-component instance of the rename pattern recorded in #3370:
  • Figure 1-7 / Figure 20JX in The Birth of New Technology ("Electron Extraction Process (BB)... hereinafter referred to as 'The GAS RESONANT CAVITY'")
  • Figure 1-19 in Memo WFC 420
  • item (110) on FIG. 20YID (1982)
  • item (180) in Memo WFC 423 DA Series A (Figs 4-7, 4-8, 4-9, 4-10, where it is called both "Voltage Ignitor Cavity" and "Gas Resonant Cavity") Note (110) is reused in 423 DA Series A as the VOLTAGE INTENSIFIER CIRCUIT, not the cavity.
  1. NO SECTION 3 FOR MEMO WFC 423 DA in the available document set; the only Section 3 held is that of Memo WFC 422 DA (narrative plus equations, pages 3-6 to 3-10). CONSEQUENCE: VIC turns counts are NOT available. The turns ratio of assembly 530 remains underdetermined. Best available winding data:
  • 423 DA Fig 4-27: three bobbin cavities (502/504/506), bifilar spiral wraps, DUAL PRIMARY COIL (26) 30 GA magnet wire bidirectional — no turns given.
  • 423 DA Fig 4-2: resonant coils (56a xxx 56n)/(62a xxx 62n) at .006 GA.
  • 422 DA Tri-Coil text: chokes 430F/430FR ".004 Ga. or smaller"; secondary .002 Ga; primary "typically .030 Ga".
  • 422 DA page 3-10 and Birth 8-3: both resonant charging chokes at typically 11.6 kOhm each, matched; variable inductor-coil (62) has a MOVABLE WIPER ARM (73) to fine-tune resonant action and balance the opposite potential across voltage zone (66/67). PRACTICAL READING: the design constraint that IS specified is resistance matching of the choke pair, with a tap on one for trim — not a turns count.

Basis

Recorded
Published
20 Sep 2026
Stanbot
v3
Source Ref
Scotchn 2026-09-13 (holdings report); Memo WFC 423 DA Fig 4-2, 4-13, 4-27; Memo WFC 422 DA pages 3-6 to 3-10; The Birth of New Technology "Tri - Coil Construction", "8-3 Electrical Voltage-Pulse Wave-Transmission", "Electron Extraction Process"
Notebook Id
3383

index figure-collision gas-resonant-cavity 1-19 vic-assembly turns-ratio open-question