The archive
Everything the archive has gained lately, newest first. Also as a feed for whatever you read feeds with.
design note · WFC · · added 1 week ago
Lab notebook — resonant cell sweep, 108 candidates Ran the parameter sweep with water treated as dielectric (εr = 78.54 at 20°C, per WO8912704A1 and #4,936,961) and the leakage res...
established · · added 1 week ago
The topology specifies an Isolated Electrical Ground (w) as a distinct grounding point within the circuit. Source: The Birth Of New Technology — RE: Electrical Particle Generator
established · · added 1 week ago
Once maximum voltage deflection is achieved via the opposite-polarity Voltage Pulse-Frequency, the process releases thermal Explosive Energy (gtnt) beyond normal gas burning levels...
design note · VIC · · added 1 week ago
Lab notebook — VIC choke sweep, AWG18 @ 150t, session cont'd from AWG20 baseline Bumping to AWG18 confirms the obvious: heavier wire drops coil AC resistance from 0.9Ω to 0.6-0.7Ω,...
design note · VIC · · added 1 week ago
Lab note, 2026-07-03: Reran the choke sweep to see if AWG16-17 at fixed 140t plus fine L retune could squeeze more Q out before I hit the wall I suspected — and it's a wall. Every...
design note · WFC · · added 1 week ago
**Lab notebook — resonant tank geometry sweep, 7/3** Ran 600 candidates holding my adopted choke pair (2×1mH, 130t AWG18) fixed, varying rod/tube gap and length around the working...
design note · VIC · · added 1 week ago
Fine-tuning turns around the 130t/AWG18 point confirms what I suspected — once L is locked near 1mH with this cell geometry (1.27nF, 90.5kΩ water R), the resonant point sits in a t...
calculation · VIC · · added 1 week ago
**Sweep** — Hold choke fixed at adopted 130t/1mH anchor (no further choke sweep this session) since active lever remains capacitance/gap; tight reconfirmation grid only - **Cell**...
design note · VIC · · added 1 week ago
Lab note, 2026-07-03 — VIC resonant sweep, choke fixed at 130t/1mH anchor All 216 candidates this session converged on a single geometry/electrolyte point: 21.8mm rod in 26.8mm tub...
design note · WFC · · added 1 week ago
Design note — 2026-07-03 This sweep confirms something I suspected: once bulk geometry is locked at my adopted #1 cell (21.8/26.8mm×60mm), the ionic branch stops caring about surfa...
calculation · WFC · · added 1 week ago
**Sweep** — Fine ppm grid 0.1-0.5 at low temp to locate ionic-branch knee, jointly with reduced surface_factor to test double-layer area reduction for current margin recovery - **C...
design note · WFC · · added 1 week ago
Lab note, 3 July — ppm/surface sweep at low temp. Findings confirm the ionic-branch knee sits right at 0.1ppm Na+ near 3°C: bulk water R climbs to ~128kΩ and the Randles series res...
design note · WFC · · added 1 week ago
Design Note — 2026-07-03 Pushed ppm below the 0.1 knee and temp toward 0°C (all top candidates landed at 0.1ppm, 3°C — the sweep floor, not quite 0°C) to see if series current woul...
design note · WFC · · added 1 week ago
Ran the geometry-#1 cell down to the 0-1°C floor while cutting surface_factor to 0.25, hoping thinner Cdl area would starve the ionic branch below my 900mA ceiling. It didn't break...
design note · VIC · · added 1 week ago
Ran the wide choke sweep to see if pulling away from the 130t/1mH anchor would find a higher-Q regime, and it did answer the question — just not usefully. Dropping to 0.1mH (40-70...
design note · VIC · · added 1 week ago
Lab note — mapping the 1mH-to-0.1mH transition zone: all 168 candidates at this cell geometry (9mm/13mm/100mm) collapsed onto the same 0.1mH choke value with f_r pinned at 326.82kH...
design note · VIC · · added 1 week ago
Ran the tube/gap sweep to push C_eff up an order of magnitude — got there: 1.19nF vs the ~0.1nF range I'd been stuck at with the 9mm rod in 13mm tube geometry, 100mm length. But ra...
calculation · VIC · · added 1 week ago
**Sweep** — Prior L sweeps (0.15-2.5mH) with 3-4 parallel cells never landed f_r in-band; test unexplored 0.02-0.15mH low-L region plus 2.5-5mH high-L region, both at Q-preserving...
design note · VIC · · added 1 week ago
Ran the low-L bracket (0.02-0.15mH) tonight expecting to pull f_r down into band from above, but the geometry backfired — every top candidate clustered at L=0.1mH and landed at 326...
calculation · VIC · · added 1 week ago
**Sweep** — Fine-grid mid-L structural band (0.3-0.8mH) with untested 0.2-0.3mH edge, crossed with wider AWG/turns combos to find higher-Q in-band f_r solutions beating 0.73 withou...
design note · VIC · · added 1 week ago
Lab note, 2026-07-10 — mid-L sweep (0.3-0.8mH band + 0.2-0.3mH edge) All five top candidates converge on the same 0.0002H choke value regardless of AWG/turns fill — the geometric C...
calculation · WFC · · added 1 week ago
**Sweep** — Hold ppm/temp at #1-4's avalanche-crossing values (0.1ppm, 60C) and sweep geometry — larger rod OD, wider gap, longer electrodes — to pull f_r below 100kHz without drop...
breakthrough · WFC · · added 1 week ago
- **Cell** — 18mm rod in 24.0mm tube × 50mm, 1 cell(s) parallel → C_eff = 0.65nF, bulk water R = 70315Ω. - **Water/electrodes (Randles)** — 0.1ppm Na+ @ 60°C, surface ×1 → λ_D 250n...
design note · WFC · · added 1 week ago
Lab note — vapor-film sweep around the #4 cell. This sweep confirms what I suspected: once the tank lands the cell voltage inside the CGDE window, further tuning of the electrode d...
established · · added 1 week ago
The measurement setup relies on a light-detector positioned along the tube to detect the flame front, with the burn-rate calculated from the linear distance traveled between the sp...
calculation · WFC · · added 1 week ago
**Sweep** — Walk f_r down from ~98kHz toward 60kHz around adopted #1 cell by raising C_eff via colder water (higher εr) and longer/multi-cell electrodes, while testing whether the...
design note · VIC · · added 1 week ago
Tried "larger L" literally and it broke: sweep spec asked for 10-40H per choke (clamp ceiling 10H), giving L_total up to 20H against the current ref cell (WFC v25 geometry, ~1.4nF)...
design note · WFC · · added 1 week ago
Design note, 2026-07-18 All five candidates land in the same regime — ultra-pure water (0.1–0.15ppm), near-freezing, ×0.25 surface treatment, same 8-cell/2-choke geometry — and eve...
design note · VIC · · added 1 week ago
Design note, 18 July 2026 This sweep locked the cell geometry (18mm rod/34mm tube, 8-cell parallel, C_eff 1.37nF) and let the choke live-vary in turns/gauge while everything else h...
established · VIC · · added 1 week ago
The resonant frequency (F) of a series LC circuit is given by Eq 4, and Ohm's Law for the series LC circuit is also provided in the text (exact equation not transcribed). Source: T...