Skip to content
Stan’s Legacy
Sign in

(36)

Tubular Pathway

Also written bearing surface · tubular bearing · tubular surface

Where it is first named

Coil (46) is wound (400 turns 30 ga. insulated wire) on molded nylon bobbin (47) that is placed inside a magnetic "shunt-assembly" (48) and slipped over said tubular bearing (36), as illustrated in Figure 26E as to Figure 26F and Figure 28.
— ELECTRICAL PARTICLE GENERATOR

How it is written

  • (36) 5×

Drawings 1

Where it is named · 5

ELECTRICAL PARTICLE GENERATOR 5×

  1. tubular bearing (36)

    Coil (46) is wound (400 turns 30 ga. insulated wire) on molded nylon bobbin (47) that is placed inside a magnetic "shunt-assembly" (48) and slipped over said tubular bearing (36), as illustrated in Figure 26E as to Figure 26F and Figure 28.

    Read it there → · on Figure (26E)

  2. tubular pathway (36)

    A second magnetic bar key (39) is inserted into said tubular pathway (36) and properly aligned to said coil-array (30/30)... forming an air gap (42) between said tubular surface (36) and said Magnetic Key Assembly (39)... completing the field effect forming said cavity (41)... and structuring pulsing effect itself (35).

    Read it there →

  3. tubular surface (36)

    A second magnetic bar key (39) is inserted into said tubular pathway (36) and properly aligned to said coil-array (30/30)... forming an air gap (42) between said tubular surface (36) and said Magnetic Key Assembly (39)... completing the field effect forming said cavity (41)... and structuring pulsing effect itself (35).

    Read it there →

  4. tubular pathway (36)

    Typical cross-sectional diameter of said tubular pathway (36) may vary up to and beyond 1/2 inch O.D.

    Read it there →

  5. bearing surface (36)

    To reach maximum acceleration performance, said Magnetic Keeper Bar (39) moves said moving fluid-mass (3) closer to said bearing surface (36)... enhancing magnetic attraction force (53).

    Read it there →