Skip to content
Stan’s Legacy
Sign in

(48)

Magnetic "Shunt" Assembly

Also written magnetic "shunt-assembly" · magnetic shunt

Where it is first named

Coil (46) is wound (400 turns 30 ga. insulated wire) on molded nylon bobbin (47) that is placed inside a magnetic "shunt-assembly" (48) and slipped over said tubular bearing (36), as illustrated in Figure 26E as to Figure 26F and Figure 28.
— ELECTRICAL PARTICLE GENERATOR

How it is written

  • (48) 4×

Drawings 3

Where it is named · 4

ELECTRICAL PARTICLE GENERATOR 4×

  1. magnetic "shunt-assembly" (48)

    Coil (46) is wound (400 turns 30 ga. insulated wire) on molded nylon bobbin (47) that is placed inside a magnetic "shunt-assembly" (48) and slipped over said tubular bearing (36), as illustrated in Figure 26E as to Figure 26F and Figure 28.

    Read it there → · on Figure (26E)

  2. Magnetic "Shunt" Assembly (48)

    Said Magnetic "Shunt" Assembly (48) is composed of two metal discs (49a/49b) placed on opposite sides of said coil-bobbin (46/47) with Magnetic Key (51) situated between said pallets (49a/49b) adjacent to and wrapping said coil-bobbin (46/47).

    Read it there →

  3. Magnetic "Shunt" Assembly (48)

    Said Magnetic "Shunt" Assembly (48) is composed of electrical steel that will push the magnetic field toward said moving permanently magnetized mass, as illustrated in Figure 26F.

    Read it there → · on Figure (26F)

  4. magnetic shunt (48)

    Voltage applied to coil (46) causes current flow and creates magnetic field (41) that passes through said magnetic shunt (48)... causing magnetic flux-lines (48) to align said field effect to said fluid-mass (3).

    Read it there →