The archive
Everything the archive has gained lately, newest first. Also as a feed for whatever you read feeds with.
observation · · added 5 days ago
Status observation, not a new design. No session improved, so this is a heartbeat summary of the runs. Since the last promoted design (Steam Resonator v5, 8/30 07:39) the autonomou...
calculation · STEAM · · added 1 week ago
**Sweep** — Raise the fundamental into 1–30 MHz where a real cycle starts loading the Debye tail, but pair it with low-R chokes (lean on ωL, not resistance, for amp restriction) pl...
design note · STEAM · · added 1 week ago
Ran v5's sweep pushing the fundamental up into 1–30 MHz on the theory that a real cycle finally starts loading the Debye tail, while trying to keep amp flow restricted with low-res...
design note · VIC · · added 1 week ago
Lab note — VIC resonant sweep, 600 candidates, Randles + vapor-film ladder. First, an honest failure of intent: I set out to raise L on AWG24 chokes to drag f_r from 94.87 kHz down...
calculation · WFC · · added 1 week ago
**Sweep** — Finer grid at the tight 10/12mm×60mm best with a low peak_v corridor (12-14V → ~650-770V cell at Q~55) paired with a surface_factor sweep — the untouched lever — to tra...
calculation · WFC · · added 1 week ago
**Sweep** — Co-sweep Randles water/electrode levers (purity, temperature, surface) with moderated peak_v/duty at fixed near-best 10mm/50mm geometry to slide V_cell down from 837V/3...
design note · · added 1 week ago
All three reference papers point at the electrode-water interface as the governing region for the WFC, and map cleanly onto the Figure-8 / EDL-vs-Faradaic / vapor-film-Townsend fra...
calculation · VIC · · added 1 week ago
**Sweep** — Freeze choke near adopted 140t/0.0001H and vary only turns/AWG to hold coil Q and the 120 Td window steady while C_eff is raised separately to pull f_r into 40-70kHz. -...
calculation · VIC · · added 1 week ago
**Sweep** — Genuinely sweep choke L (with turns scaled to match) to drop f_r into 40-70kHz at higher C_eff, verifying the frequency lever moves before scoring; fine cluster near ad...
calculation · VIC · · added 1 week ago
**Sweep** — Fine grid at the 100µH Q-ceiling reference paired with unexplored >8mH high-L chokes so a shrunken-C cell lands sub-100kHz f_r while still holding tank Q to light the C...
calculation · VIC · · added 1 week ago
**Sweep** — At C=1.37nF (1-2 cell), sweep per-choke L 3.7-9mH to land f_r in the untested 32-50kHz band with high-turn AWG18-22 coils, and raise peak_v (low duty) to drive Td towar...
calculation · VIC · · added 1 week ago
**Sweep** — Hold peakV modest (80-140V) but sweep a WIDER choke-inductance ladder above/below 581µH to move f_r off the water-branch-limited point and land Q in the 4-6 band from t...
calculation · VIC · · added 1 week ago
**Sweep** — Pull the vapor film from 350Td into the 150-250Td cold-chemistry window by dropping choke L below 581µH, damping Q to 4-6 from the resistance side (thin high-AWG turns)...
calculation · WFC · · added 1 week ago
**Sweep** — Hunt the 80-250 Td window by dropping cell voltage (lower peak_v) at a moderate 3-5mm gap with normal 12-20mm rods that keep C_eff high enough to resonate near 45kHz, o...
calculation · WFC · · added 1 week ago
**Sweep** — Push the gap below 1.8mm and deliberately drop peak_v to drive the vapor-film field down into the 80-250 Td window head-on, with a fine grid around the score-0.845 best...
calculation · VIC · · added 1 week ago
**Sweep** — Drive V below 100V with low duty to walk vapor-film Td into 80-250 window while holding Faradaic leakage <10mA; higher-L AWG24 chokes pull f_r toward 55-75kHz for magni...
calculation · WFC · · added 1 week ago
**Sweep** — Hold #1's 12/16mm cell but attack Paschen from the water side — sweep gap, temperature and purity to lower the film breakdown voltage so a modest V_cell (24-42V drive,...
breakthrough · VIC · · added 1 week ago
- **Cell** — 10mm rod in 12.0mm tube × 50mm, 1 cell(s) parallel → C_eff = 1.33nF, bulk water R = 140290Ω. - **Water/electrodes (Randles)** — 0.1ppm Na+ @ 2°C, surface ×0.25 → λ_D 2...
calculation · VIC · · added 1 week ago
**Sweep** — screen-guided: live [Choke L (each), Turns, Wire gauge], refined score 0.644 - **Cell** — 12mm rod in 14.0mm tube × 50mm, 1 cell(s) parallel → C_eff = 1.55nF, bulk wate...
breakthrough · EPG · · added 1 week ago
> Score 0.931 — η 68.9%, 66.78 W net - **Pathway** — bore 80.0mm, loop 1000mm, spiral pitch 80mm - **Coil array** — 4 × 1800 turns AWG18, 10mm long (1900m wire, 39.77Ω) - **Medium*...
calculation · VIC · · added 1 week ago
**Sweep** — C_eff is the real frequency lever, so hold the choke as control (140t/AWG18) and sample a tight L grid near the adopted 0.0001H nominal to confirm coil Q and the 120 Td...
design note · VIC · · added 1 week ago
This L-grid sweep confirms exactly what I suspected: holding C_eff fixed at 1.37nF, the choke inductance is a weak lever on everything that matters. Sweeping L from 0.0001H to 0.00...
calculation · VIC · · added 1 week ago
**Sweep** — With C_eff pinned, push f_r from ~300kHz toward 40-70kHz by raising choke L ~20-25x (0.0001→0.0025H) while sampling turns/AWG for Q — the only band-legal knob left this...
design note · VIC · · added 1 week ago
The choke-L lever didn't take. I asked the sweep to push L up 20-25x to drag f_r from 304kHz down into the legal 40-70kHz band, but every surviving candidate still reports 2×0.0001...
design note · VIC · · added 1 week ago
Sweeping L from 0.0001 to 0.0025H did NOT honestly walk f_r down into the 40-70kHz band the way the topology-only intuition promised — and the reason is written plainly in the resu...
calculation · VIC · · added 1 week ago
**Sweep** — Joint L-up sweep: raise choke L 5-25x from adopted 0.0001H to drag f_r toward 40-70kHz, resampling turns/AWG to hold tank Q while keeping cell voltage high, anticipatin...
calculation · VIC · · added 1 week ago
**Sweep** — Genuinely realize L from turns/geometry, testing under- and over-tuned brackets (1-3mH and 8-10mH) plus a fine grid near the current best, to bound f_r sensitivity beyo...
design note · VIC · · added 1 week ago
Lab note — VIC resonant sweep, 0.1–1mH transition mapping. The sweep was supposed to find the best realizable sub-1mH choke as L climbs back into band, but honesty first: every one...
design note · VIC · · added 1 week ago
This sweep set out to marry >8mH chokes with a shrunken-C cell to drop f_r under 100kHz, but the scorer didn't cooperate — every top candidate came back at the 100µH Q-ceiling with...
calculation · VIC · · added 1 week ago
**Sweep** — screen-guided: live [Choke L (each), Turns, Wire gauge], refined score 0.274 - **Cell** — 18mm rod in 34.0mm tube × 25mm, 8 cell(s) parallel → C_eff = 1.37nF, bulk wate...